Garage and automatic gates and barriers need regular specialist maintenance. Servistnoe maintenance of automatic gates. To support the orderly and beautiful view to regularly cleaned surface of sandwich panels with a damp cloth with neutral detergent. If you have any additional audio loops or in the axes of rollers to apply a small amount certified lubricant into the holes for lubrication in the center of the loop or a curl in the central part of the spire holder clip. Guides must also be contained in the ideal purity. Attention! When use non-certified lubricant will damage the enamel, plastic sheeting and other materials.
If in the opening and closing the gate there is need for greater effort, then adjust rollers and torsion springs. When using electric drive to from time to time to check the position limit switches. Servicing of automatic doors should be performed every 10000 – 15000 cycles (closing the opening). Maintenance of barriers. Servicing barriers reduces the regular balancing system to prevent rapid exit from the gear system. It is also necessary, by analogy driven automatic gate control efforts and testing of terminal positions. Servicing barriers must be carried out every 15000 – 20000 cycles (opening closing).
Maintenance of automatic building doors. Adjust the speed and effort geared motor, lubrication operator exposure level of the valves and balancing. Inspection of the upper and lower rails, brush seals. Maintenance of sliding Automatic doors should make every 50000 – 60000 cycles (opening closing). When carrying out maintenance of all these mechanisms should be implemented: external examination, broaching fasteners, test tightness, check the power cables and control, health check of rolling bearings, chains, belt drives, to hold grease and readings. Remember that regular maintenance is not only 'prolongs life 'to your equipment, but also save money and time on repairs.